پروگرامر و دیباگر برای میکروکنترلرهای arm و سازگار با نرم افزار keil

نسخه غیر اورجینال و کپی

با توجه به کپی بودن (Clone) این پروگرامر عواقب هر گونه downgrade و upgrade کردن Firmware برعهده خود مشتری می باشد . همچنین توصیه می شود پس از اینکه کار با پروگرامر تمام شد از کامپیوتر جدا شود .

ARM Kail ULINK2 Debug Unit programmer
The ULINK2 debug unit connects your PC's USB port to your target system (via a JTAG, Cortex Debug, or OCDS connector). It allows you to program and debug your applications on target hardware.
ULINK2, together with MDK Version 5, provides excellent debug capabilities for Cortex-M devices. You can control the processor, set breakpoints, and read/write memory contents, all while the processor is running at full speed.

Broad Device Support:
ULINK2 connects to a wide variety of processor targets, including ARM7, ARM9, all Cortex-M, 8051, and C166 devices.
JTAG support for ARM7, ARM9, 8051, C166, and all Cortex-M processors
Serial Wire Debug (SWD) support for all Cortex-M processors
Serial Wire Viewer (SWV) support for all Cortex-M processors

Run/Stop Debugging:
Using ULINK2, you can
download programs to your target hardware
examine memory and registers
single-step through programs and insert multiple breakpoints
run programs in real-time
program Flash memory

Fast Connections:
ULINK2 offers fast and reliable target connections
Data trace for Cortex-M up to 1 Mbit/s (UART mode)
JTAG clock speed up to 10 MHz
Supports Cortex-M devices running at up to 200 MHz
Memory read/write up to 28 kBytes/s

Specification:
Wide target voltage range: 2.7V - 5.5V
USB 2.0 High-Speed connection
USB powered (no power supply required)
Target Connectors:
10-pin (0.05") - Cortex Debug Connector
20-pin (0.10") - ARM Standard JTAG Connector