Product Description:
In the process of circuit signal transmission, the voltage signal will increase
with the transmission distance becomes weak, the use of current transmission can
avoid the signal weakening.
This module is used for the end of the current signal transmission, the signal
into a voltage signal for single-chip detection. Current input support 4-20Ma,
0-20mA, voltage output support 0-3.3V 0-5V 0-10V.
Instructions for use:
Module according to the definition of wiring, power supply voltage 7-36V (if the
output to 10V, the supply voltage must be greater than 12V)
After power-up, the D2 indicator should be on, otherwise check the line
connection. Board with reverse protection, reverse does not burn.
When the current input is the minimum (0mA or 4mA), adjust the ZERO
potentiometer so that the VOUT output is the minimum (0.0V or other voltage)
When the current input is at maximum (20mA), adjust the SPAN potentiometer so
that the VOUT output is the maximum (3.3V or 5V or 10V, the output can be as low
as 2.5V when the input is 4-20ma).
According to your needs, through the jumper cap to select the appropriate range:
4--20ma: 0-2.5V range: J1 1,2 feet short, 3,4 feet shorted
0 - 3.3V range: J1 1,2 feet off, 3,4 feet off
0 - 5.0V range: J1 1,2 feet short, 3,4 feet shorted
0--10.0V range: J1 1,2 feet short, 3,4 feet off
0--20ma: 0--3.3V range: J1 1,2 feet short, 3,4 feet shorted
0 - 5.0V range: J1 1,2 feet short, 3,4 feet shorted
0--10.0V range: J1 1,2 feet short, 3,4 feet off
ماژول مبدل جریان به ولتاژ HW-685 (XY-IT0V) Current to Voltage
- تولید کننده: China - A
- دسته بندی ها:
- - ماژول تغذیه ، مبدل ولتاژ ، اینورتر و پاور بانک
- کد محصول: NN_201_22D002_000000_12711
- موجودی: در انتظار خرید از خارج
-
قیمت پایه :
عدم موجودی
جهت خرید تعداد بالا تماس بگیرید