пВї ماژول مودم انتقال اطلاعات روی خط برق PLC - مدل KQ-130F | مجتمع الکترونیک ایران میکرو

به دلیل بروز رسانی و انبارگردانی تا چند روز آینده امکان ثبت سفارش در سایت وجود ندارد . در صورت نیاز می توانید از طریق 09039407345 در ایتا یا واتساپ با ما در تماس باشید .  


ثبت درخواست واردات قطعات ثبت درخواست تهیه از بازار فرصت شغلی در ایران میکرو مرکز دانلود
  • ماژول مودم انتقال اطلاعات روی خط برق PLC - مدل KQ-130F

Introduction:
KQ-130F is a single-row 9-pin small-volume high-performance zero-crossing carrier data transceiver module. It is a cost-effective carrier module specially designed and developed for reliable transmission of data under 220V AC, strong interference, strong attenuation, and long-distance requirements. Suitable for meter reading, street lighting, smart home, fire protection, building control and other applications where power lines are required to transmit data.

KQ-130F series performance:
1. Integrated KQ-330F module and peripheral circuit carrier board, no need for other coupling components, directly connected to 220V AC. The outer dimensions are 53×38×17 mm (L×D×H), and the single row of pins is led out (see the figure below). The pins are connected to the 220V AC power supply without direction (1 pin, 2 pin spacing 2X0.1 inches). 2 feet, 3 feet are 1.1 inches apart, and the remaining feet are 0.1 inches apart.
2. The working frequency is 120~135KHZ, and the interface baud rate is 9600bps. The actual baud rate is 100bps, 250 bytes of buffer.
3. Temperature range: -25 ° C ~ +70 ° C Humidity ≤ 90%
4. Power supply: DC +5V Receive: ≤11mA When transmitting: ≤300mA

Pin Description:
1P--AC: Firewire (or neutral) of 220V AC voltage
2P--AC: Zero line (or fire line) of 220V AC voltage
3P--+5V: +5V transmit power (260mA), if the data can be suspended, the power consumption can be suspended.
4P--GND: Digital circuit ground
5P--+5V: +5V working power 11mA
6P--RX: TTL level, carrier data input, connected to the TXD of the single chip, high resistance input can not be left floating
7P--TX: TTL level, carrier data out, connected to the RXD of the microcontroller
8P--MODE: mode selection, floating or connected to 5V is high level, grounding is low level
9P--NC/RST: The reset pin (active low) is only used when switching modes frequently during operation. Need this function, the pin should be left floating

نظر بدهید

ورود

ماژول مودم انتقال اطلاعات روی خط برق PLC - مدل KQ-130F

  • قیمت پایه : 6,806,250ریال

  • ارسال رایگان سفارشات بالای 3 میلیون تومان



ارزان تر سراغ دارید ؟ اطلاع دهید

تعداد بازدید: 7863


پرسش و پاسخ مشتریان



برچسب ها: POWER LINE CARRIER MODULE

'