Specification
Stainless steel sheath and waterproof
Temperature control range: -50 to 120°C
Resolution: -9.9 to 99.9 hours 0.1°C Other temperature range 1°C
Temperature measurement accuracy: 0.2% FS
Temperature control accuracy: 0.1°C
Refresh rate: 2 times / sec
Input power: 12V-24V-220V optional (see purchase parameters)
Measurement input: NTC10K (B3950) 1-meter waterproof sensor
Output type: relay output, maximum capacity 10A
Environmental requirements: -30 ~ 60 ° C humidity 20% - 85%
Instruction
1. Connect the power supply and load according to the instructions. Be careful
not to overpressure and overload!
2. Setting mode, long press SET for 5 seconds will display P0 Short press SET to
set H (red light) to heating mode C (green light) to cooling mode
3. Set the stop temperature, press the SET screen once. Press the up and down
keys to directly set the desired temperature.
4. ENT is the confirmation button. Press and hold this button to realize the
function of power on/off.
Please connect the power supply according to the parameters and wiring diagram,
and connect the cooling or heating equipment to the output.
Enter the internal setting as needed to select the heating (into PO selection H)
or cooling (into PO selection C) mode to set the temperature method, press the
SET screen once, press the upper and lower to set the desired temperature, press
ENT to confirm the OUT indicator of the return panel. Light: Blinking indicates
cooling or heating start delay, always on indicates the output
Digital tube: Display LLL for sensor open circuit: display HHH is out of
measurement range, the thermostat will force power off, display --- for
high-temperature alarm.
Notice:
1. The input terminal is connected to the power supply. +V is the positive GND
is the negative pole. Do not exceed the range according to the type of power
supply.
2, the output type is relay output, the load needs to be connected in series at
the output, the maximum capacity is 10A
3. After connecting the line, you must first set the cooling or heating. When
finished, press the SET screen when the temperature is normally displayed. Press
the up and down to set the required stop temperature.
4. Before starting the machine, press and hold the power up and down to release
the factory to restore the factory settings
ماژول ترموستات و کنترلر دمای دیجیتال با رله XH-W1308 - مدل 12VDC
- تولید کننده: China - A
- دسته بندی ها:
- - سنسور ، ماژول دما و رطوبت
- کد محصول: RG_110_02A006_000000_14338
- موجودی: 10
-
قیمت پایه : 2,084,500ریال
ارسال رایگان سفارشات بالای 3 میلیون تومان
تعداد بازدید: 768
پرسش و پاسخ مشتریان
برچسب ها: ماژول ترموستات و کنترلر دمای دیجیتال با رله XH-W1308 - مدل 12VDC, RG_110_000000_000000_14338, سنسور ، ماژول دما و رطوبت